remote usb-controlled-poe

This command controls power (on or off) to AudioCodes Power-over-Ethernet (PoE) injector and thus, to the cellular module (Mediant 5G-EA and Mediant 5G-EA-G). The PoE injector can be ordered from AudioCodes.

Power management is achieved by connecting the PoE injector’s USB port to the device’s USB port, using a special USB cable (purchased from AudioCodes). Once connected, this command is run with the status of the cellular interface (shutdown or no shutdown).

Syntax

remote usb-controlled-poe

Default

By default, PoE is always on.

Note

■

For more information, refer to the document Mediant 5G-EA and 5G-EA-G Cellular Module Hardware Installation and Configuration Guide.

■

This command is applicable only to data-router functionality.

Command Mode

Privileged User

Example

This example powers off the PoE injector and thus, cellular module:

(config-data)# interface cellular 0/0
(conf-cellular-0/0)# remote mode m5g-ea-g

(conf-cellular-0/0)# remote underlying GigabitEthernet 0/0

(conf-cellular-0/0)# sim slot 1
(conf-cellular-0/0)# remote usb-controlled-poe
(conf-cellular-0/0)# remote mgmt-vlan 4051 data-vlan 4052 4053
(conf-cellular-0/0)# obscured-pin RXR3dnk=

(conf-cellular-0/0)# shutdown
(conf-cellular-0/0)# exit